LeadEPC was contracted during 2016 to replace the redundant 3.3KV Variable Speed Drive for the Reducing Mill of the Rod Mill at ArcelorMittal, Newcastle works. The RM has a 2.5MW, 3.3KV motor. A fully regenerative solution was required. An ABB ACS6000 Drive Unit was implemented. The ACS6000 Drive is water cooled. The functionality of the […]

Design, Manufacturing, Supply, Delivery to Site, Installation and Commissioning of one Multi-drive for the replacement of Group 3 AC Multi Drive System and the re-use of the existing motors and motor cables. The project entailed the replacement of the existing Drive Systems for continuous Pickling Line No 3 at ArcelorMittal, Vanderbijlpark facility. Scope of Work: […]

Repair work on a Cold Mill at Hulamin in Pietermaritzburg can be summarized as follows: Scope of Work: Remove all damaged cabling Remove damaged cable support Verify and revise documentation such as Load Lists, Cable Schedules and Termination Diagrams Propose Material Lists Site establishment with Safety File and Risk Assessment Procure material Install new equipment […]

This project entailed the Design and Supply of a new 11kV Starter and Motors for the Blast Furnace D Baghouse. Scope of Work:  2 X 11kV Motors  1 X 11kV Auto Transformer  11kV Switchgear  PLC Control System  Power/Control Cabling The project was successfully implemented for ArcelorMittal at the Vanderbijlpark facility.

Supply, Install and Commission of a Variable Speed Drive with motor. Scope of Work: 1 X 1250KVA Transformer 1 X 900kW Induction Motor 1 X 690V Variable Speed Drive complete in Panel 1 X Local Operator Panel Refurbish one 3.3KV Circuit Breaker All Power Cabling All Control Cabling This project entailed the Engineering, Supply, Installation […]